13 — Instrumentation Engineering
Dead Weight Tester
A pressure calibration instrument that applies calibrated weights to a piston-cylinder system to generate known reference pressures for calibrating pressure gauges and transmitters.
01 — Same Category
More in Instrumentation Engineering
-
11
Class B Push-Pull Amplifier
A demonstration circuit of a Class B push-pull amplifier configuration used to teach crossover distortion and power-amplifier efficiency concepts.
-
12
Class A, B, C, D, E Commutation Trainer Kit
A power electronics trainer kit that demonstrates Class A through Class E thyristor commutation circuits used to teach SCR turn-off techniques.
-
13
Control System Trainer
A trainer module used to study open-loop and closed-loop control system responses, including stability and transient behavior, in control engineering laboratories.
-
14
Control Valve Trainer Setup
A process instrumentation trainer built around an actual control valve used to teach valve characteristics, actuation, and flow control response.
-
15
Controlled Rectifier with R and RL Load
A power electronics experiment setup that demonstrates the output waveform of a controlled rectifier under resistive and resistive-inductive loads.
-
16
Cut-Section Model of Different Valves
A cutaway physical model exposing the internal construction of various valve types, used to teach valve design and working principles in instrumentation laboratories.
-
18
DIAC Trainer Kit
A power electronics trainer kit used to study the breakover and triggering characteristics of a DIAC in triggering circuits for thyristors and triacs.
-
19
Digital Interactive Smart Board
An interactive touch-enabled display board used for digital classroom instruction and demonstration of laboratory concepts in engineering departments.
-
20
Digital Storage Oscilloscope
A bench instrument that captures, displays, and stores electrical waveforms used to measure voltage, frequency, and timing characteristics of signals in electronics laboratories.
-
21
Dual DC Regulated Power Supply (30V, 3A)
A bench power supply providing two independently regulated 0-30V, 3A DC outputs used to power electronic circuits and trainer kits during laboratory experiments.
-
22
Dual DC Regulated Power Supply (30V, 5A)
A bench power supply providing two independently regulated 0-30V, 5A DC outputs used to power higher-current electronic circuits and trainer kits in laboratory experiments.
-
23
ECG Trainer Kit
A biomedical instrumentation trainer kit that demonstrates the acquisition, amplification, and filtering of electrocardiogram signals for teaching medical electronics.
Need Dead Weight Tester?
Tell us your requirement and we will get back to you.