13 — Instrumentation Engineering
Control System Trainer
A trainer module used to study open-loop and closed-loop control system responses, including stability and transient behavior, in control engineering laboratories.
01 — Same Category
More in Instrumentation Engineering
-
07
Bourdon Tube Trainer with LVDT
A pressure-measurement trainer that couples a Bourdon tube sensing element with an LVDT to convert mechanical deflection into an electrical signal for teaching pressure transducer principles.
-
08
Capacitive-Type Level Measurement Setup
A laboratory setup using a capacitive probe to measure liquid level by sensing changes in capacitance, used to teach capacitive level-sensing techniques.
-
09
Cascade Control Trainer Setup
A process control trainer with primary and secondary control loops used to teach cascade control strategy and controller tuning in process instrumentation laboratories.
-
10
Class A Power Amplifier Experimental Kit
An experimental kit built around a Class A power amplifier circuit used to study biasing, gain, and distortion characteristics in analog electronics laboratories.
-
11
Class B Push-Pull Amplifier
A demonstration circuit of a Class B push-pull amplifier configuration used to teach crossover distortion and power-amplifier efficiency concepts.
-
12
Class A, B, C, D, E Commutation Trainer Kit
A power electronics trainer kit that demonstrates Class A through Class E thyristor commutation circuits used to teach SCR turn-off techniques.
-
14
Control Valve Trainer Setup
A process instrumentation trainer built around an actual control valve used to teach valve characteristics, actuation, and flow control response.
-
15
Controlled Rectifier with R and RL Load
A power electronics experiment setup that demonstrates the output waveform of a controlled rectifier under resistive and resistive-inductive loads.
-
16
Cut-Section Model of Different Valves
A cutaway physical model exposing the internal construction of various valve types, used to teach valve design and working principles in instrumentation laboratories.
-
17
Dead Weight Tester
A pressure calibration instrument that applies calibrated weights to a piston-cylinder system to generate known reference pressures for calibrating pressure gauges and transmitters.
-
18
DIAC Trainer Kit
A power electronics trainer kit used to study the breakover and triggering characteristics of a DIAC in triggering circuits for thyristors and triacs.
-
19
Digital Interactive Smart Board
An interactive touch-enabled display board used for digital classroom instruction and demonstration of laboratory concepts in engineering departments.
Need Control System Trainer?
Tell us your requirement and we will get back to you.