13 — Instrumentation Engineering
Class A, B, C, D, E Commutation Trainer Kit
A power electronics trainer kit that demonstrates Class A through Class E thyristor commutation circuits used to teach SCR turn-off techniques.
01 — Same Category
More in Instrumentation Engineering
-
06
Biomedical Trainer Kit
A trainer kit used to demonstrate the acquisition and processing of physiological signals for teaching biomedical instrumentation principles.
-
07
Bourdon Tube Trainer with LVDT
A pressure-measurement trainer that couples a Bourdon tube sensing element with an LVDT to convert mechanical deflection into an electrical signal for teaching pressure transducer principles.
-
08
Capacitive-Type Level Measurement Setup
A laboratory setup using a capacitive probe to measure liquid level by sensing changes in capacitance, used to teach capacitive level-sensing techniques.
-
09
Cascade Control Trainer Setup
A process control trainer with primary and secondary control loops used to teach cascade control strategy and controller tuning in process instrumentation laboratories.
-
10
Class A Power Amplifier Experimental Kit
An experimental kit built around a Class A power amplifier circuit used to study biasing, gain, and distortion characteristics in analog electronics laboratories.
-
11
Class B Push-Pull Amplifier
A demonstration circuit of a Class B push-pull amplifier configuration used to teach crossover distortion and power-amplifier efficiency concepts.
-
13
Control System Trainer
A trainer module used to study open-loop and closed-loop control system responses, including stability and transient behavior, in control engineering laboratories.
-
14
Control Valve Trainer Setup
A process instrumentation trainer built around an actual control valve used to teach valve characteristics, actuation, and flow control response.
-
15
Controlled Rectifier with R and RL Load
A power electronics experiment setup that demonstrates the output waveform of a controlled rectifier under resistive and resistive-inductive loads.
-
16
Cut-Section Model of Different Valves
A cutaway physical model exposing the internal construction of various valve types, used to teach valve design and working principles in instrumentation laboratories.
-
17
Dead Weight Tester
A pressure calibration instrument that applies calibrated weights to a piston-cylinder system to generate known reference pressures for calibrating pressure gauges and transmitters.
-
18
DIAC Trainer Kit
A power electronics trainer kit used to study the breakover and triggering characteristics of a DIAC in triggering circuits for thyristors and triacs.
Need Class A, B, C, D, E Commutation Trainer Kit?
Tell us your requirement and we will get back to you.