13 — Instrumentation Engineering
Controlled Rectifier with R and RL Load
A power electronics experiment setup that demonstrates the output waveform of a controlled rectifier under resistive and resistive-inductive loads.
01 — Same Category
More in Instrumentation Engineering
-
09
Cascade Control Trainer Setup
A process control trainer with primary and secondary control loops used to teach cascade control strategy and controller tuning in process instrumentation laboratories.
-
10
Class A Power Amplifier Experimental Kit
An experimental kit built around a Class A power amplifier circuit used to study biasing, gain, and distortion characteristics in analog electronics laboratories.
-
11
Class B Push-Pull Amplifier
A demonstration circuit of a Class B push-pull amplifier configuration used to teach crossover distortion and power-amplifier efficiency concepts.
-
12
Class A, B, C, D, E Commutation Trainer Kit
A power electronics trainer kit that demonstrates Class A through Class E thyristor commutation circuits used to teach SCR turn-off techniques.
-
13
Control System Trainer
A trainer module used to study open-loop and closed-loop control system responses, including stability and transient behavior, in control engineering laboratories.
-
14
Control Valve Trainer Setup
A process instrumentation trainer built around an actual control valve used to teach valve characteristics, actuation, and flow control response.
-
16
Cut-Section Model of Different Valves
A cutaway physical model exposing the internal construction of various valve types, used to teach valve design and working principles in instrumentation laboratories.
-
17
Dead Weight Tester
A pressure calibration instrument that applies calibrated weights to a piston-cylinder system to generate known reference pressures for calibrating pressure gauges and transmitters.
-
18
DIAC Trainer Kit
A power electronics trainer kit used to study the breakover and triggering characteristics of a DIAC in triggering circuits for thyristors and triacs.
-
19
Digital Interactive Smart Board
An interactive touch-enabled display board used for digital classroom instruction and demonstration of laboratory concepts in engineering departments.
-
20
Digital Storage Oscilloscope
A bench instrument that captures, displays, and stores electrical waveforms used to measure voltage, frequency, and timing characteristics of signals in electronics laboratories.
-
21
Dual DC Regulated Power Supply (30V, 3A)
A bench power supply providing two independently regulated 0-30V, 3A DC outputs used to power electronic circuits and trainer kits during laboratory experiments.
Need Controlled Rectifier with R and RL Load?
Tell us your requirement and we will get back to you.