11 — Electrical & Electronics
EV Motor Controller Testing System
Test bench for characterising traction motor controllers under load, with programmable duty cycles, thermal monitoring and data logging. Used for performance validation and fault-condition study.
01 — Same Laboratory
More in Electric Vehicle Technology
-
198
Electric Vehicle Training Kit
Sectioned electric-vehicle powertrain on a frame — battery, controller, traction motor, throttle and instrumentation — with test points throughout. Provides an integrated introduction to EV architecture and energy flow.
-
199
EV BLDC Motor and Controller Trainer
Traction-grade BLDC motor with its electronic controller, Hall feedback and loading arrangement. Used to study commutation, throttle response, torque-speed behaviour and controller protection features.
-
200
EV PMSM Motor Trainer
Permanent-magnet synchronous traction motor with field-oriented controller and encoder feedback for studying vector control and field weakening. Represents the drive used in current-generation electric vehicles.
-
201
EV Battery Management System Trainer
BMS trainer with a multi-cell pack, cell monitoring, balancing and protection circuitry and diagnostic software. Demonstrates state-of-charge estimation, cell balancing and fault cut-off.
-
202
Lithium-Ion Battery Pack Training System
Instrumented lithium-ion pack with series-parallel configuration, thermal sensing and safety interlocks for charge-discharge characterisation. Covers pack assembly, capacity testing and thermal behaviour.
-
203
EV Charging Station Trainer
Training charger covering AC Level 1/2 and DC fast-charging concepts with connector types, control pilot signalling and protection. Demonstrates the charging handshake and safety sequence.
-
204
EV On-Board Charger Trainer
On-board charger trainer with a power-factor-corrected front end and isolated DC output, instrumented for efficiency and waveform study. Shows how AC supply is converted to regulated pack charging current.
-
205
EV DC-DC Converter Trainer
Isolated bidirectional DC-DC converter trainer stepping traction-pack voltage down to the auxiliary bus. Used to study high-frequency conversion, isolation and bidirectional power flow in vehicles.
-
206
EV Regenerative Braking Trainer
Trainer demonstrating energy recovery during braking, with a flywheel or dynamometer load, bidirectional controller and energy metering. Quantifies the energy returned to the pack under different braking profiles.
Need EV Motor Controller Testing System?
Tell us your requirement and we will get back to you.