11 — Electrical & Electronics
EV BLDC Motor and Controller Trainer
Traction-grade BLDC motor with its electronic controller, Hall feedback and loading arrangement. Used to study commutation, throttle response, torque-speed behaviour and controller protection features.
01 — Same Laboratory
More in Electric Vehicle Technology
-
198
Electric Vehicle Training Kit
Sectioned electric-vehicle powertrain on a frame — battery, controller, traction motor, throttle and instrumentation — with test points throughout. Provides an integrated introduction to EV architecture and energy flow.
-
200
EV PMSM Motor Trainer
Permanent-magnet synchronous traction motor with field-oriented controller and encoder feedback for studying vector control and field weakening. Represents the drive used in current-generation electric vehicles.
-
201
EV Battery Management System Trainer
BMS trainer with a multi-cell pack, cell monitoring, balancing and protection circuitry and diagnostic software. Demonstrates state-of-charge estimation, cell balancing and fault cut-off.
-
202
Lithium-Ion Battery Pack Training System
Instrumented lithium-ion pack with series-parallel configuration, thermal sensing and safety interlocks for charge-discharge characterisation. Covers pack assembly, capacity testing and thermal behaviour.
-
203
EV Charging Station Trainer
Training charger covering AC Level 1/2 and DC fast-charging concepts with connector types, control pilot signalling and protection. Demonstrates the charging handshake and safety sequence.
-
204
EV On-Board Charger Trainer
On-board charger trainer with a power-factor-corrected front end and isolated DC output, instrumented for efficiency and waveform study. Shows how AC supply is converted to regulated pack charging current.
-
205
EV DC-DC Converter Trainer
Isolated bidirectional DC-DC converter trainer stepping traction-pack voltage down to the auxiliary bus. Used to study high-frequency conversion, isolation and bidirectional power flow in vehicles.
-
206
EV Regenerative Braking Trainer
Trainer demonstrating energy recovery during braking, with a flywheel or dynamometer load, bidirectional controller and energy metering. Quantifies the energy returned to the pack under different braking profiles.
-
207
EV Motor Controller Testing System
Test bench for characterising traction motor controllers under load, with programmable duty cycles, thermal monitoring and data logging. Used for performance validation and fault-condition study.
Need EV BLDC Motor and Controller Trainer?
Tell us your requirement and we will get back to you.