12 — Mechatronics Engineering
Cathode Ray Oscilloscope (0-20 MHz, Dual Trace, Dual Beam) with Component Tester
A dual-trace, dual-beam cathode ray oscilloscope with a bandwidth of 0-20 MHz and an integrated component tester, used to observe waveforms and test electronic components in the laboratory.
01 — Same Category
More in Mechatronics Engineering
-
03
Raspberry Pi Kit for 4-Digit 7-Segment LED Display
A Raspberry Pi based application kit configured to drive a 4-digit 7-segment LED display, used to teach GPIO output control and multiplexed display interfacing.
-
04
Raspberry Pi Kit for Smart Street Light System
A Raspberry Pi based application kit that simulates an automated street lighting system, used to teach sensor-based automation and embedded control logic.
-
05
Raspberry Pi Kit for Agriculture Application
A prototype Raspberry Pi based kit configured for an agricultural monitoring and control application, used to teach embedded sensing and automation for agri-tech use cases.
-
06
Programmable Logic Controller (PLC) Trainer Kit
A trainer kit built around a Programmable Logic Controller, used to teach ladder logic programming and industrial automation control sequences.
-
07
PLC-Based Pulse Counting Trainer Kit (Limit Switch)
A PLC-based trainer kit that counts pulses generated by a limit switch, used to teach event counting and digital input handling in industrial automation.
-
08
Logic Gate Truth Table Verification Trainer Kit
A digital electronics trainer kit used to verify the truth tables of logic gates, teaching fundamental Boolean logic and combinational circuit behavior.
-
10
Dual Power Supply
A dual-channel DC power supply used to provide adjustable voltage and current to electronic and mechatronics experiment circuits.
-
11
Function Generator with TTL Output (2 MHz)
A signal generator producing standard waveforms with a TTL-compatible output up to 2 MHz, used to supply test signals for digital and analog circuit experiments.
-
12
Electromagnetic Flow Meter
An instrument that measures the flow rate of conductive liquids using electromagnetic induction, used to teach non-contact flow measurement principles.
-
13
Flow Measurement Trainer Kit (Ultrasonic, Electromagnetic, Rotameter)
A multi-method trainer kit that demonstrates flow measurement using ultrasonic, electromagnetic, and rotameter techniques, used to compare flow-sensing principles in an instrumentation laboratory.
-
14
Force Measurement Kit
A trainer kit used to demonstrate force measurement techniques, such as load-cell or strain-based sensing, in mechatronics laboratory experiments.
-
15
Shaft Power Measurement Trainer
A trainer setup used to measure the mechanical power transmitted through a rotating shaft, teaching torque-speed based power computation.
Need Cathode Ray Oscilloscope (0-20 MHz, Dual Trace, Dual Beam) with Component Tester?
Tell us your requirement and we will get back to you.