11 — Electrical & Electronics
Power System Stability Trainer
Set-up in which a synchronous machine connected to an infinite bus is subjected to load and fault disturbances so swing behaviour and the stability limit can be observed. Supports steady-state and transient stability experiments.
01 — Same Laboratory
More in Power Systems
-
121
Transmission Line Model
A scaled physical model of an electrical power transmission line used to demonstrate line parameters and transmission performance.
-
122
String Efficiency Measurement and Calculation Model
A demonstration model used to measure and calculate the string efficiency of suspension insulator strings used on high-voltage transmission lines.
-
123
Radial and Ring Main Distribution System
A demonstration setup used to teach the layout and operating differences between radial and ring main electrical power distribution systems.
-
124
Symmetrical and Unsymmetrical Fault Demonstrator
A demonstration unit used to simulate symmetrical and unsymmetrical fault conditions in power systems for protection and fault-analysis studies.
-
125
Transmission Line Simulator
A scaled physical model of a transmission line with adjustable resistance, inductance, and capacitance per unit length, used to study line parameters and performance.
-
126
Power System Simulation / Training Panel
Integrated panel representing generation, transmission, distribution and load on one board, with metering, breakers and fault switches. Allows a complete power-system experiment sequence on a single training station.
-
127
Load Flow Analysis Trainer
Trainer combining a scaled multi-bus network model with load-flow software so measured bus voltages and line flows can be compared against Gauss-Seidel and Newton-Raphson results. Bridges the analytical and laboratory sides of the power-systems syllabus.
-
129
Alternator Synchronisation Panel
Panel carrying synchronising switch, check-synch relay, metering and lamp or synchroscope indication for paralleling an alternator with the bus. Used for the synchronisation and load-sharing practicals.
-
130
Synchroscope
Rotating-pointer synchroscope indicating the frequency difference and phase relationship between an incoming machine and the running bus. Shows the correct instant for closing the synchronising switch.
-
131
Three-Phase Synchronising Lamps Set
Three-lamp synchronising arrangement wired for both the dark-lamp and bright-lamp methods, with phase-sequence indication. Provides the classical demonstration of alternator paralleling.
-
132
Power System Operation and Control Trainer
Trainer demonstrating load-frequency control, automatic voltage regulation and economic load dispatch on a scaled two-area system. Covers the operation-and-control portion of the power-systems syllabus.
-
133
SCADA Power System Training Kit
Substation SCADA kit with RTU, communication link and HMI software for remote monitoring, breaker control and event logging of a scaled power network. Introduces students to modern substation automation practice.
Need Power System Stability Trainer?
Tell us your requirement and we will get back to you.