11 — Electrical & Electronics
Feed-Forward Control System Test Set-Up
Set-up illustrating feed-forward control, in which measured disturbances are compensated before they affect the process output. Allows comparison of feed-forward, feedback, and combined control strategies on the same plant.
01 — Same Laboratory
More in Control Systems
-
173
AC Servomotor Torque Characteristics Test Set-Up
Set-up for determining the torque-speed characteristics of a two-phase AC servomotor at varying control-winding voltages. Illustrates the near-linear characteristics that make AC servomotors suitable for low-power feedback control applications.
-
174
Analog PID Controller Set-Up
Op-amp based analog controller set-up in which proportional, integral, and derivative actions can be configured individually or in combination. Allows students to observe the effect of each control action on the step response of a simulated process.
-
175
Digital PID Controller Test Set-Up
Microprocessor-based PID controller test set-up with adjustable gain, integral, and derivative settings applied to a simulated or real process. Teaches digital implementation of PID control, tuning methods, and comparison of closed-loop responses.
-
176
Compensation Test Set-Up (Lag / Lead / Lag-Lead)
Set-up for studying lag, lead, and lag-lead compensation networks and their effect on the frequency and transient response of a control system. Enables measurement of magnitude and phase characteristics for compensator design exercises.
-
177
Basic Open-Loop Control System Test Set-Up
Demonstration set-up of an open-loop control configuration in which the output is not fed back to the input. Used to show the limitations of open-loop operation, such as sensitivity to disturbances and parameter variations, as a foundation for feedback control study.
-
178
Basic Closed-Loop Control System Test Set-Up
Set-up demonstrating a negative-feedback closed-loop control system, with measurable reference, error, and output signals. Teaches the effect of feedback on accuracy, disturbance rejection, and stability compared with open-loop operation.
-
180
AC Position Control System Test Set-Up
Closed-loop angular position control system built around an AC servomotor with synchro or potentiometric feedback. Students study transient response, steady-state error, and the effect of gain on the performance of an AC servomechanism.
-
181
DC Position Control System Test Set-Up
Closed-loop position control set-up using a DC servomotor with position feedback, allowing adjustment of loop gain and observation of the resulting response. A standard experiment for studying second-order system behaviour, overshoot, and settling time.
-
182
Tachogenerator
DC or AC tachogenerator with mounting and readout for converting shaft speed into a proportional voltage. Used as the feedback element in speed-control and servo experiments.
-
183
Temperature Control Trainer
Closed-loop temperature control rig with heater, sensor and controller supporting ON-OFF, P, PI and PID modes. Used for tuning exercises and for studying set-point tracking and disturbance rejection.
-
184
Level Control Trainer
Two-tank level control rig with pump, control valve, level transmitter and controller for single-loop and cascade control experiments. Demonstrates the dynamics of an integrating process.
-
185
Process Control Trainer
Multi-variable process rig covering flow, level, temperature and pressure loops on one skid with a common controller and data-acquisition interface. Provides a complete process-control laboratory in a single unit.
Need Feed-Forward Control System Test Set-Up?
Tell us your requirement and we will get back to you.